木質地板是天然木材經烘干、加工后形成的地面裝飾材料。現在很多家庭都會選擇木質地板來進行裝修。但是如果地板鋪設不得當，功用也會減半。然而，三分地板七分安裝，地板材質再好，也要精心安裝。那么木質地板怎么鋪才好呢？跟木質地板廠家一起來看看吧！
一、直接粘貼鋪設法
這種適用于350mm長的地板，而且要求地面平實。直接粘貼鋪設法是將地板直接粘接在地面上，這種安裝方法快捷，施工時要求地面十分干燥、干凈、平整。由于地面平整度有限，過長的地板鋪設可能會產生起翹現象，因此更實用于長度在30cm以下的實木及軟木地板的鋪設。一些小塊的柚木地板、拼花地板必須采用直接粘接法鋪設。直接粘貼法適合用于拼花地板與軟木地板，此外，復合木地板也可使用直接粘貼方式鋪裝。
二、夾板龍骨鋪設法
夾板龍骨鋪設法是先鋪好龍骨，然后在上邊鋪設毛地板，將毛地板與龍骨固定，再將地板鋪設于毛地板之上，這樣不僅加強了防潮能力，也使得腳感更加舒適，柔軟。夾板龍骨鋪設法適用地板毛地板龍骨鋪裝方式適合用于實木地板、實木復合地板、強化復合地板和軟木地板等多種地板，在龍骨上鋪一層毛地板，再以懸浮式鋪法等方式鋪貼地板。優點是防潮性好，腳感舒適。但是損耗較多的層高，相對于其他方法的成本也更高。
三、懸浮鋪設法
鋪裝地板的走向通常與房間行走方向相一致或根據用戶要求，自左向右或自右向左逐徘依次鋪裝，凹槽向墻，地板與墻之間放入木楔，留足伸縮縫，干燥地區，地板又偏濕，伸縮縫應留小；潮濕地區因地板偏干，伸縮縫應留大。拉線檢查所鋪地板的平直度，安裝時隨鋪隨檢查，在試鋪時應觀察板面高度差與縫隙，隨時進行調整，檢查合格后才能施膠安裝。一般鋪在邊上 2-3排施少量D4或無水環保膠固定即可。其余中間部位完全靠榫槽嚙合，不用施膠。
